Investing in a garage door is the best choice for every household owner.
The device functions at a heavy-duty rate and lasts for up to ten to fifteen years.
However, it’s not every time that the garage door opener is going to work correctly.
There will come a random day that the garage door suddenly stops working or the door doesn’t fully open.
Before contacting the nearest garage door repair available, here are some tips for identifying a malfunctioning garage door motor.
Observe The Garage Door
The first thing in the rule book is to make sure to check the door.
Whether or not the garage door functions properly or not, this is a crucial thing for you to do.
Apply lubricant and spray the sides of the door, along with its hinges, for smooth movement.
Inspect the chains and the overhead door’s screws for any rust that might have built-up.
Above the overhead door, you will see the tracks: a huge mechanism responsible for creating the door’s mechanism.
These tracks tend to misalign due to over usage of the garage door.
The next thing to do is check to see if your garage door can now come to open or close.
Moreover, it is important to inspect whether the garage door springs are functioning properly.
A damaged spring could be the leading cause of broken garage door motors.
For more information regarding how to carefully do garage door installation, check out this video below.
Inspect Garage Door’s Sensors
Garage door sensors tend to shift away from their original position after consistently having the garage door open and close.
Like the previous case, one of the reasons why the remote or signal connectivity for most automatic doors tend to malfunction is due to the poor sensor range.
Inspect the door’s sensor to see if dust particles have been blocking its lenses.
Built-up dirt around the sensor’s surroundings or surface tends to cause the poor connection from the remote to the garage door motor unit.
Next, grab a clean cloth; it’s time to get some cleaning done.
A dirty sensor can be the cause of a garage door opener motor not working properly.
Check Power Supply
Another important to-do before calling the nearest garage door repair service is to check the power supply or the door’s remote controller.
Most garage doors sold and purchased by households these days automatically come with remote controls and connect to the household’s power supply.
When a garage door opener motor is not working, it is also a good idea to observe the power supply to make sure the outlet is fully connected.
Wait for a minimum of fifteen minutes before trying to open the garage door once more.
This way, you allow its motor to cool down for a bit.
An overheating motor can cause wreckage to the power supply and garage door, so make sure that the engine is in its normal state before getting it to work again.
Troubleshooting Remote Control
Another simple error is forgetting to change the remote control’s batteries.
If replacing the old batteries on the remote control solves the problem, we can be assured that the issue won’t require us to call for professionals.
However, if the remote control still doesn’t work after plugging in a new set of batteries, you may need to buy a brand new remote control.
In most situations, the garage door’s old remote control must have deprogrammed, which may have caused complications.
Can’t find high-quality garage door repairs in Philadelphia? Contact Garage Doors Philly now!
Garage doors are the toughest parts of our household, and it’s essential to give them proper care and repair in cases of the garage door opener motor not working.
Our technicians at Garage Doors Philly have all the possible needs for your next garage door repair, not only on garage door motors but its entire hardware.
We do not only specialize in household overhead door repairs but also with commercial garage doors too.
Garage door opener motor not working? No worries, not only do we offer garage door motor repairs, but also garage door installation.
Contact us for your garage door repair needs!